1. Add water for water chamber
Rotate the upper cover of the water chamber counterclockwise to remove it → push the water chamber out of the machine → add water to between the MIN line and the MAX line → push the water chamber horizontally into the machine → tighten the upper cover of the water chamber clockwise.
2. Power on
3. Parameter setting
Rotate the control dial to move the blue cursor to "Settings" → Mode selection: CPAP, S, S/T, (T) → Set the corresponding parameters in each mode;
Rotate the control dial to move the blue cursor to "System" → set the heater position → turn on or off each alarm prompt.
4. Mask wearing
5. Tube connection
6. Start treatment
Note:
1. When adding water, the water chamber must be pushed out from the inside of the machine before adding it. Do not add water directly after opening the top cover of the water chamber ;
2. After the treatment is turned off, if there is water in the water chamber, do not move or turn the machine upside down. Pour the water inside the water purification box first, and then put the machine back to prevent water from entering the device.